Ramsey Electronics SG560 Podręcznik Użytkownika Pobierz pdf (Strona 10)

BASIC USE

Saving and Recalling Memories:

To save a memory, set up the SG560 into the desired frequency, level, offset and wave shape.

Press SHIFT, STO and the memory location a through f. These settings are stored in non-

volatile FLASH memory for recall and will be saved whether or not power is applied to the

unit. Be careful; saving a memory will automatically overwrite whatever was previously in that

memory location without prompting to be sure you want to overwrite!

Example: Save a setup to memory location b

To recall a memory, press RCL and then any location from a-f and all characteristics of the

saved waveform will be loaded and activated. The current selected memory location is shown

as a character in the upper right of the display.

As a special feature, memory location a is automatically recalled upon startup of the SG560.

This can be set to whatever state is preferred for power up. Setting memory location a to 0Hz,

0 level, and 0 offset simulates a mute condition, or the SG560 can be set up for the user’s

most common test setup.

Adjusting Display Contrast

Display contrast settings are not saved when the unit is powered down, but can be adjusted

by pressing SHIFT, then the MHz and kHz buttons to increase or decrease contrast.

Property of Ramsey Electronics, Inc.

Do not reproduce or distribute.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Brak uwag

Ramsey Electronics SG560 Podręcznik Użytkownika Strona 10